AWS Set up: Difference between revisions
Jump to navigation
Jump to search
| Line 10: | Line 10: | ||
</syntaxhighlight> | </syntaxhighlight> | ||
You will need to have a config file which defines your AWS Profiles to use | You will need to have a config file which defines your AWS Profiles to use | ||
< | <syntaxhighlight lang="bash"> | ||
[bibble-nz-prod] | [bibble-nz-prod] | ||
region=ap-southeast-2 | region=ap-southeast-2 | ||
| Line 18: | Line 18: | ||
region=ap-southeast-2 | region=ap-southeast-2 | ||
output=json | output=json | ||
</ | </syntaxhighlight> | ||
You will need to have a credentials file | You will need to have a credentials file | ||
< | <syntaxhighlight lang="bash"> | ||
[bibble-nz-prod] | [bibble-nz-prod] | ||
aws_access_key_id=ABC1 | aws_access_key_id=ABC1 | ||
| Line 28: | Line 28: | ||
aws_access_key_id=ABC2 | aws_access_key_id=ABC2 | ||
aws_secret_access_key=456 | aws_secret_access_key=456 | ||
</ | </syntaxhighlight> | ||
Revision as of 03:28, 18 February 2022
Introduction
This is the place where all of my setup I feel needs noting is done.
Serverless
There are some perquisites before starting
sudo npm install -g serverless
sudo npm install -g serverless-bundle
sudo npm install -g aws-sdk
sudo npm install -g aws-cli
You will need to have a config file which defines your AWS Profiles to use
[bibble-nz-prod]
region=ap-southeast-2
output=json
[bibble-nz-nonprod]
region=ap-southeast-2
output=json
You will need to have a credentials file
[bibble-nz-prod]
aws_access_key_id=ABC1
aws_secret_access_key=123
[bibble-nz-nonprod]
aws_access_key_id=ABC2
aws_secret_access_key=456