Raspberry Pi

Introduction

Just some notes in case I forget.

Setting Up

For the openssh-server you need to install and then use rasp-config to activate For sudoers you need to EDITOR=vi visudo For the UART set it in the config.txt and to redirect bluetooth add

enable_uart=1  
dtoverlay=pi3-miniuart-bt                                                       
dtoverlay=pi3-disable-bt

Change the baud rate in the cmdline.txt

console=serial0,38400 console=tty1 root=PARTUUID=330e768f-02 rootfstype=ext4 elevator=deadline fsck.repair=yes

If used on a Model b+ pins 6,8 and 10 where 6 is gnd, 8 is TXD and 10 is RX. Don't forget RX->TX and TX->RX with UART